Part Number: SB255

Description: Low Seat Bracket

Fitment: 98-05 Mazda Miata

Details:

These LOW style brackets were designed around the Sparco Sprint seat but will work with other similar sized side mounted seats. They are designed to get the seat as low and far back as possible for those taller drivers. They are not compatible with sliders so there are mutiple slots and holes to fine tune the seating position.

IMPORTANT- They will work on side mounted seats with front mounting holes no more than 3-7/8 inches high from the bottom of the seat, and rear mounting holes no more than 3-1/2 inches high from the bottom of the seat. Seats with side mounting holes higher than this will not be compatible.

The Planted Seat Bracket is a vehicle specific bracket used as an adapter between the floor of the vehicle and an aftermarket seat and it's accessories. Because the floor of each vehicle varies and typically is not flat, a vehicle specific Seat Bracket is required for installing an aftermarket seat. We create each seat bracket using the floor of the vehicle as a reference. We literally bring each vehicle into our development center so we can create the best fitting, bolt in, universal seat bracket possible.

NIVERSAL. STRONG. SECURE

Planted Seat Brackets are laser cut from 3/16 inch thick steel and hand welded to ensure weld penetration for superior strength. Each bracket is pre-slotted with hole patterns to accept sliders from most major seat manufacturers like Braum, Bride*, Cipher Auto, Cobra**, Corbeau, Momo, NRG, OMP, Racetech, Recaro, Sabelt, Sparco, Status Racing, Takata and more. There is extra space on the bracket for drilling your own hole pattern if using a slider with a less common hole pattern, or direct mounting a seat or side mount when eliminating sliders is preferred. 

DISCLAIMERS

• Seats come in many different shapes and sizes so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit prior to ordering the Seat Bracket and other components.

• Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size then the factory seat.

• Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor but it is up to the end user to determine if a resistor will work & which resistor to use.

• Professional installation is recommended.