Part Number: A12100

Description: Cobb 4 Bar Map Sensor Cast Manifold Sensor Only

Fitment: 08-14 Subaru STi

Notes: Not for sale in California not CARB Legal

Details:

Emissions

This part is legal under the provisions of EPA’s Anti-Tampering Policy. COBB Tuning has established a reasonable basis (testing results) to verify that this product allows the vehicle to operate within legal emissions standards and is therefore legal to be sold for on-street use in all states that accept the legal provisions of the Clean Air Act and EPA’s Anti-Tampering Policy.

NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY EMISSION CONTROLLED MOTOR VEHICLE.

Testing with the California Air Resources Board, in order to achieve 50-state compliance, is pending. Once testing is complete with California, and an EO number is issued, this product will be updated to 50-state legal status.

Description

Our Subaru 4 Bar MAP Sensor is a plug and play solution that allows for precise measurement of pressures up to 4 Bar.

The pressure sensor itself is made up of a stainless steel body and flying leads terminated into an OEM quality connector, allowing for direct plug-and-play installation into supported Subarus.

• Accurate to within +/- 1% Full Scale

• Linear 0.5v to 4.5v Output

• <1ms Response Time

• 0-60psi Absolute Pressure Measurement

SENSOR ONLY, REQUIRES 1/8" NPT ADAPTER FOR INSTALL

Why?

Most Subarus are equipped with either a 2.5 or 3 bar MAP sensor from the factory which allows accurate reading up to either 21.5psi or 28.8psi (respectively). For vehicles targeting boost values higher than that, an upgraded sensor is required for accurate measurement and control.

Custom Tuning Required

Features

COBB Subaru 4 Bar MAP Sensor - Cast Manifold WRX/STI/FXT - Sensor Only

• OEM Quality Plug-and-Play Connector

• 1/8" NPT Threads

• Total Error Band <1% Full Scale (+/- 0.6psi)

• <1ms Response Time

• Retains OEM Sensor DTC Detection Capabilities